![]() |
Andrew Beattie - 1,686 views - 0 comments - 0 likes
- posted by Ok, so start with removing the 6 screws to seperate the Boiler and Body from the Chassis. careful with a couple of delicates that need pulling out.
Remove the black and red wires carefully and all their attachments. The only wires left should be the power to motor and feedback for the chuff S...
|
![]() |
Dick Friedman - 1,215 views - 0 comments - 0 likes
- posted by After a hot day of running trains with my MRC 6200, the trains stopped suddenly. A quick check revealed no power going to the track. There was power to the accessory terminals, however. It was hot and the end of the day, so I decided to let it cool down overnight and check it out t...
|
![]() |
Jon Radder - 3,316 views - 0 comments - 0 likes
- posted by Ride Along with Housatonic RR NX-13
|
![]() |
Jon Radder - 4,619 views - 0 comments - 0 likes
- posted by Experiments & Preliminary Work
Within a few days of owning my Live Steam 2 Cylinder Open Cab Shay I was convinced that an R/C installation was going to be necessary. Even though the Shay is very easy to keep up with and control by hand, the design of my railroad made that impractical. Each run r...
|
![]() |
Bob McCown - 4,542 views - 0 comments - 0 likes
- posted by R/C and Battery Power for the Berlyn Goose #6
|